Difference between revisions of "Tutorials/Arduino Projects/RC car Hacking Project/Connecting the Arduino"
(Created page with "<yambe:breadcrumb>Arduino_Projects|Arduino Tutorials and Guided Projects</yambe:breadcrumb> Physically connecting the Arduino can be a challenge or fairly simple depending on...")
Revision as of 20:17, 3 July 2012
Physically connecting the Arduino can be a challenge or fairly simple depending on the size of the vehicle. Skip to the section appropriate to your vehicle.
A Large vehicle
On a large vehicle, like the Interceptor, we will be using a full-size Arduino UNO, as well as a small breadboard.
The first thing to do is analyze the vehicle and find where we can place both the Arduino and the breadboard without impeding the placement of the covering as we aim to replace this once the hack is completed. Looking at the Interceptor, a good place for the Arduino and breadboard seems to be here:
Attaching the Arduino
Now we need to investigate how to attach the components. The Arduino is above a hollow surface so it will need to stand off it by an inch or so. To do this, we will use standoffs. You can use any type you like. We used TETRIX standoffs as their screws fit the Arduino nicely.
WARNING! Adult supervision required when using power tools!
You need to drill holes in the base of the chassis which line up with the Arduino. You will need no more than two.
Now, it is a simple matter to screw in the standoffs...
And finally attach the Arduino to the top.
Attaching the breadboard
Since the breadboard is not as vital a piece of equipment, and because it comes with an adhesive backing, using zip-ties to secure it will be perfectly fine.
Be sure to trim the ends when finished.
Now you have attached the components, you are ready to begin wiring.