What is an LED?
What is an LED?
An LED (Light Emitting Diode) is an electronics component that emits light when powered. Like all diodes, LEDs only allow current to flow through them in one direction, meaning that they must be wired in the correct direction in order to function. LEDs have two opposite leads, a cathode (the positive lead) and an Anode (the negative lead). To make it possible to identify which lead is which, LEDs are created with two distinctive properties: The Anode lead is longer than the Cathode lead, and the LED is notched on the side of the Cathode lead. Even if the leads have been damaged or clipped, you can still look for the notched part of the LED to identify the cathode.
When referencing a schematic (drawing of the electrical pathways and components using symbols), the symbol for the LED shows which way the current flows and allows you to connect the LED the correct way. The cathode on the symbol is the side with the line across the point of the triangle and the anode is the other side. It is important to note that there are many variations on the schematic symbol, however, they all have a triangle with a line across the point and one or two arrows pointing out.
How to Wire an LED
To wire an LED, you need an LED, a breadboard, some wires, and a 470Ω resistor (color code: yellow-violet-brown). A resistor is an electronics component that limits the flow of electricity. This is important because some components, like LEDs, will be damaged or destroyed if too much current flows through them. Thus, we need resistors to protect the LED.
Wiring an LED is very simple. All you need to do is connect one lead of the resistor to digital pin 5 on the Arduino. Connect the other lead of the resistor to the anode lead of one of the LEDs, and then connect the cathode to ground.
To make this easier, we will use the breadboard.
Understanding the circuit
The Arduino digital pin in this circuit is configured as a digital output, which can be thought of in this setup as connecting the circuit to the power (5V) when set to high, or connecting it to the Ground connection when set to low. When it is high, the current will flow from the pin, through the resistor and through the LED, then into the ground connection. (In electronics, the ground connection refers to the voltage supply connection that has 0 volts).
The LED requires about 2 volts across the leads to operate correctly. However, The Arduino's power supply provides 5 volts, 3 volts too many. Thus, we use a resistor to bring the voltage down to an appropriate level. The resistor also serves a a current limiter to prevent excessive current from flowing through the LED and damaging it.
For a series circuit (one in which the components are connected one after the other), the sum of the voltage drop (voltage drop - the amount of voltage used by a component, i.e. the difference in voltage across the connections) across each component must be equal to the source voltage, which in this case is 5 volts. Since the LED needs 2 volts, the resistor must have a voltage drop of 3 volts. Additionally, in series circuits the current (amperes or amps abbreviated as A) flowing through each component is the same. Based on these two properties, it is possible to calculate the required resistance of the resistor using (Vs·VLED)/ILED=R, where Vs is the supply voltage, VLED is the voltage across the LED, ILED is the desired current flowing through the LED, and R is the resistance of the resistor. We already selected the 470Ω resistor because it provides a nice safety range for variances of the components.