Requirements for Using a Touch Sensor
From ROBOTC API Guide
Arduino → Arduino Tutorials and Guided Projects → Lego + Arduino, Mobile Robotics Platform → Tutorials/Arduino Projects/Mobile Robotics/Lego/Prerequisites for Touch Sensors
|
Previous sections
- Getting started with Arduino
- Using LEDs
- Robot Motion
Parts List
- LEGO+Arduino Robot Base with DFRobot Motor Shield
- 1 LED (preferably Red, but the examples use an Orange LED) - can be found at www.sparkfun.com [1]
- At least nine Jumper wires of various sizes and colors - These can be found anywhere, but the ones used in the examples came from a combination of www.sparkfun.com [2] and www.jameco.com [3]
- 1 470Ω resistor - again, my be found in many places, but ours are from www.sparkfun.com [4] (The sparkfun kit contains a large number of resistors of various types to suit any electronics projects you have in mind)
- 3 NXT connector wires - can be found in the standard NXT kit.
- 3 Breadboard Connector Kits for NXT - can be found at www.Mindsensors.com [5]
- 1 LEGO touch Sensor - can be found in the standard NXT kit
