The problem I have been having is that when I set every external controller in my programming in the motor and sensors setup page and now only the S1 controller works
SO for example if I change the Motor controller to Servo controller only the the servo will run not the motors even though I put the motor in the second section
Also I have a question on how do we use 2 controllers
Thanks to anyone who is willing to help Team 7006- RObotitans
Mon Nov 25, 2013 6:03 pm
Joined: Sat May 18, 2013 1:24 pm Posts: 271 Location: Olympia, WA
Re: Programming help!!!!
I don't know what you're doing with the setup, but to daisy-chain the motor controllers you just plug an NXT cable into the other socket of your first controller (it should have two), and the other end into your next controller.
Users browsing this forum: No registered users and 2 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum