View unanswered posts | View active topics It is currently Sat Dec 20, 2014 2:38 am






Reply to topic  [ 3 posts ] 
Cortex UART questions 
Author Message
Rookie

Joined: Fri Jul 08, 2011 11:38 am
Posts: 4
Post Cortex UART questions
Hi, I'm experimenting around with the serial ports on the Cortex microcontroller with the current version of ROBOTC and firmwares.

Couple noob questions of someone could help me:

1) I am able to program UART1 fine, however UART2 seems to be used by some system purpose. I am hoping to use both UART's on an autonomous program, no need for joystick or wifi Vexnet stuff. Is it possible to use UART2? Is the debugger using it? I am programming the Cortex using the direct USB cable.

2) Why are the constants for 1200 and2400 and 4800 commented out in the BaudRates.h and RobotCIntrinsics.c ?

3) I know this is a hardware question, but are the two RJ-9 on the side of the Cortex labeled RX1 and RX2 different than the UART1 and UART2 connectors on the top of the Cortex?

Thx in advance!


Fri Jul 15, 2011 2:48 am
Profile
Site Admin
Site Admin

Joined: Tue May 15, 2007 9:02 am
Posts: 406
Post Re: Cortex UART questions
Hi dproffer,

UART2 is set up to communicate with the VEX LCD screen by default. If you go to Window > Menu Level > Expert, and then Robot > Motors and Sensors Setup, you will find a tab labeled Serial Ports. From there you can set the UART to be used as "User Program Control".

They were not needed, so they were commented out to safe space.

Yes, they are different. The RJ ports are for connecting to the older, RF communication modules.

_________________
Jesse Flot
CMU Robotics Academy
ROBOTC Support


Mon Jul 18, 2011 8:57 am
Profile
Rookie

Joined: Fri Jul 08, 2011 11:38 am
Posts: 4
Post Re: Cortex UART questions
Hi Jesse,
Thanks very much for your answers to my noob Q's!

I've got a much better handle on the serial ports now and have both under my control.

I will uncomment the lower baud rates and see if I can communicate at them, I have one old school slow poke that I would like the Cortex to talk to.

I understand the legacy RF ports now, would be cool to figure out a way to repurpose these for some function, though I am guessing they are controlled by the base controller software.

Thanks again!

Dave


Tue Jul 19, 2011 11:51 pm
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 3 posts ] 

Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software for PTF.