ROBOTC.net forums
http://www.robotc.net/forums/

update firmware
http://www.robotc.net/forums/viewtopic.php?f=69&t=10556
Page 1 of 1

Author:  bhstech [ Thu Feb 19, 2015 11:38 pm ]
Post subject:  update firmware

I just downloaded the new 4.3 for my Vex IQ and I also downloaded the firmware, again. I also changed from a sensorbot to the clawbot so I need to reconfigure the motors to operate the claw and arm and new location of the sensors.
I can't get to the firmware update on a reliable basis. I got to it once but everything was grayed out. wouldn't work. Now I can't get back to it. Instructions on the website are severely lacking. I attempted to use the F5 approach, doesn't work.
How can I update to my new configuration?

Author:  JohnWatson [ Thu Feb 26, 2015 3:53 pm ]
Post subject:  Re: update firmware

Are you referring to the VEX IQ Master Firmware, which is updated using the VEX IQ Firmware Update Utility provided by VEX (I'm assuming this is the case, as you mentioned all the options were greyed out), or the ROBOTC firmware, which is updated through ROBOTC?

I will need more information (a screenshot of the failed firmware update will help) on this issue before I am able to assist; if the issue is with the VEX Firmware Update Utility, you will need to contact VEX directly for further assistance with this issue (http://www.vexiqforum.com/).

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/