ROBOTC.net forums
http://www.robotc.net/forums/

Duplicate config defined names
http://www.robotc.net/forums/viewtopic.php?f=63&t=19563
Page 1 of 1

Author:  goeckerd [ Wed May 17, 2017 1:56 pm ]
Post subject:  Duplicate config defined names

Why does this not produce an error?

#pragma config(Sensor, in1, Right, sensorReflection)
#pragma config(Sensor, in2, Center, sensorReflection)
#pragma config(Sensor, in3, Left, sensorReflection)
#pragma config(Motor, port1, Right, tmotorVex269_HBridge, openLoop, reversed)
#pragma config(Motor, port10, Left, tmotorVex269_HBridge, openLoop)

"Right" and "Left" are defined twice. In this case "Right" happens to be 0 in both cases so it works. However, "Left" is defined as 2 for the sensor but then redefined later as 9 by the motor definition. The "Left" sensor does not work in the code because it points to the wrong port.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/