ROBOTC.net forums
http://www.robotc.net/forums/

NXT ignoring the written code
http://www.robotc.net/forums/viewtopic.php?f=63&t=14194
Page 1 of 1

Author:  Korndog [ Fri Apr 29, 2016 4:22 pm ]
Post subject:  NXT ignoring the written code

I have one NXT that will not follow the code that was last downloaded to it. It seems as though it truly has a mind of it's own, by turning one direction or another without any explanation. I downloaded the firmware back to the brick, thinking this might reset the brick. This did not solve the problem.

Does anyone have any other ideas of how to reset the brick and wipe it clean? Thanks!

Author:  CARBOT [ Sun May 01, 2016 11:06 am ]
Post subject:  Re: NXT ignoring the written code

Write something very simple then send it to the brick to see it it works. Perhaps there is a motor you could run for 3 seconds. Very simple.

It is likely you have a bug in your code. Try hitting the code format button the indent things to make it readable.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/