I need help about an incremental encoder
Page 1 of 1

Author:  Maria88 [ Wed Jul 30, 2014 8:52 am ]
Post subject:  I need help about an incremental encoder

Hi All

Plz I need help , simply, Is it possible to add an incremental encoder to the DC gear motor of robot below to determine position and orientation ? and if it is , is there any specific incremental encoder you could advice me ?

Many thanks


Author:  JohnWatson [ Wed Jul 30, 2014 10:50 am ]
Post subject:  Re: I need help about an incremental encoder

There are several factors that you will need to determine through research; first, what is the size of the output shaft of the motor, what type of shaft is it (round, squared, etc), what type of microcontroller is driving the robot, what type of encoders are you looking at, etc. You will need to research all of this information before it can be determined if existing encoders will work on this robot style.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group