Second HiTechnic Controller?
Page 1 of 1

Author:  CapBruins [ Thu Nov 06, 2008 4:07 pm ]
Post subject:  Second HiTechnic Controller?

I am attempting to add a second HITechnic Motor controller.
is there a place where I might find directions or a "schematic"

Thanks john

Author:  tfriez [ Thu Nov 06, 2008 4:33 pm ]
Post subject:  Re: Second HiTechnic Controller?

In ROBOTC, we have two default configuration for using the second motor controller. You can go to Motors and Sensor Setup when set to the "FTC" platform type. It's fairly self explanatory

As for wiring, it can either attached at the end of your current chain of HiTechnic devices (Sensor Port 1: Motor-Servo-Motor), or can be attach to Sensor Port 2 directly.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group