Re: loaded 1.46 and now our servos don't work
I think I may know what the issue is:
This code will set the position of the servo to whatever the Left X-Axis value is on Joystick 2
... I'm betting that you don't have a second joystick, but I could be wrong.
You should change his line of code to...
That will make it run from Joystick 1.
The other thing to try is to set your servoTargets to specific position (like 100,200, 220) instead of joystick values in order to test it.
Also make sure you have the Joystick Debugger window open, or else you won't send any joystick messages and neither the servos nor motors will move.
ROBOTC Developer - SW Engineertfriez@robotc.net