Question About Cable Winding Mechanism
we have the project that is due next week Friday
Cable Winding Mechanism
A telecommunications contractor need you team design a device that can accurately wind up a specific length of cable.
The device must be able to wind a specific length consistently. The device must also be able to be started and stopped(emergency) by using a switch.
what I think is:
I want to start the motor when I press bumb1
the motor will go -63 and 63 depends the value of SONAR<30 and SONAR>=30
If the length is 60, then will go up by auto. And if the length is 20, then it will go down by auto.
The bumb2 will stop the Motor no matter when the length is at
when I press the bumb2 again the motor will start again
*We have thing that is on the rope, so the Sonar will knows how far is it. But it has +-2cm
*We have to stop the motor first before we change the direction
this is what I wrote:
is this right?