ROBOTC.net forums
http://www.robotc.net/forums/

FTC_TeleOP program freezes NXT brick
http://www.robotc.net/forums/viewtopic.php?f=52&t=828
Page 1 of 1

Author:  Koryu_Ninja [ Thu Oct 16, 2008 9:18 pm ]
Post subject:  FTC_TeleOP program freezes NXT brick

Hey, my team has noticed that the TeleOP program sometimes freezes the NXT brick while it's running, so we have to take out the battery and put it back in to restart it. Is this just us or have other had this problem, and is there a known remedy?

Author:  Jeff McBride [ Thu Oct 16, 2008 9:23 pm ]
Post subject:  Re: FTC_TeleOP program freezes NXT brick

Can you post your code? You haven't given us much to work with.

Author:  Koryu_Ninja [ Fri Oct 17, 2008 12:35 pm ]
Post subject:  Re: FTC_TeleOP program freezes NXT brick

Sorry. We're using the pre-made FTC_teleop program that came with the FTC software CD's. I don't have it on hand at the moment because I'm at home and it's at school. I'll try to get it today.

Author:  Jeff McBride [ Fri Oct 17, 2008 1:01 pm ]
Post subject:  Re: FTC_TeleOP program freezes NXT brick

Hmm. I don't see a program with that name in the RobotC Sample Programs directory. What version of RobotC are you running? I suggest trying out the TankArcade.c program that Dick posted in the version 1.46 release annoucement thread in this section of the forum.

Author:  Koryu_Ninja [ Fri Oct 17, 2008 1:23 pm ]
Post subject:  Re: FTC_TeleOP program freezes NXT brick

Okay, I'll download that and try it out on the robot. We were using version 1.44 up until yesterday when we found out about the 1.46 upgrade.

Author:  Koryu_Ninja [ Fri Oct 17, 2008 8:40 pm ]
Post subject:  Re: FTC_TeleOP program freezes NXT brick

Well, I found the file at school and it turns out it's actually in Labview format. It came with Labview and is used through the Controller Station. I'm not 100% on how to find the actual code and if it can be transferred to RobotC, but it's a Labview problem and not a RobotC problem.

Author:  Jeff McBride [ Fri Oct 17, 2008 9:04 pm ]
Post subject:  Re: FTC_TeleOP program freezes NXT brick

Labview and RobotC are mutually exclusive. You have to even replace the firmware in the NXT to go back and forth between them.

You need to decide which programming language you want to use. I suggest going to this site:
http://www.education.rec.ri.cmu.edu/content/events/ftc/index.htm

There are three buttons on the left side of the page that will give you tutorials for the three programming languages that you can use.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/