ROBOTC.net forums
http://www.robotc.net/forums/

Continuous servo Trouble
http://www.robotc.net/forums/viewtopic.php?f=52&t=7683
Page 1 of 1

Author:  dmetal1 [ Tue Jan 14, 2014 2:10 am ]
Post subject:  Continuous servo Trouble

I am the main programmer for FTC 6273. I am having problems, with getting continuous servos to stop. Every time I activate code they just move. I can't link the code right now, as this is my home computer. If someone could give me advise, it would greatly appreciated.

Author:  MHTS [ Tue Jan 14, 2014 3:43 am ]
Post subject:  Re: Continuous servo Trouble

Remember continuous servo is different from standard servo. For standard servo, a value zero will get you to one extreme and a value of 255 will get you to the other extreme. But for a continuous servo, a value of 0 will spin one way at max speed and a value of 255 will spin the other way at max speed. A value of 127 will stop the motor.

Author:  dmetal1 [ Tue Jan 14, 2014 12:30 pm ]
Post subject:  Re: Continuous servo Trouble

Thanks I will try that today. I am doing this code, because my engineer friend made a 6 degrees of freedom arm.

Author:  RobertHony [ Tue Jan 21, 2014 2:14 am ]
Post subject:  Re: Continuous servo Trouble

IS your problem solved by the solution suggested here? Else it would be great if you can attach the code.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/