OKay, we are going to do a demonstration so our club can continue next year. At the FTC competition, the officials put the code to connect to their field, but now our Sam won't connect to our computer, so we need a way to dedlete the config files on the Samantha and put our one back on it. Anone know how?

Basically, set up your router on your computer, then run the configuration program that is installed when you install the other software. Tthere's a program that you run on the main computer (SamoCfg) where you plug in a thumb drive and it writes a new configure file. Then you plug that thumb drive into the samantha module and turn it on...

never mind reading my rambling details, I found the instructions here: http://www.usfirst.org/roboticsprograms ... ogram.html

which is a sub-set of the global samantha help docs here:
http://www.usfirst.org/roboticsprograms ... x?id=17465

Nope, that was what I did and our Sam still wasn't working.

Ahhhhh, Samantha.... So many bugs.
Try pressing the button and powercycling a few times.
Also, we found that if 2 copies of the FCS are open at once, only one will work.