|
Page 1 of 1
|
[ 4 posts ] |
|
programming problem, fcs samantha nxt robotc?
| Author |
Message |
|
zotbotz
Rookie
Joined: Fri Dec 17, 2010 5:11 pm
Posts: 2
|
 programming problem, fcs samantha nxt robotc? so, i was running a program in robotc from samo fcs and i downloaded it normally, it compiled, and then i hit run in the samo fcs and the nxt gave an error.
PmgCnt: 000161
Type: 23
it gave the error all of the several times that i ran it, with modifications, the 161 is hexadecimal but the 23 is not.
it can also happen in robolab so it is not robotc specific
|
| Fri Dec 17, 2010 5:29 pm |
|
|
|
MHTS
Guru
Joined: Sun Nov 15, 2009 5:46 am
Posts: 1023
|
Re: programming problem, fcs samantha nxt robotc? Does the same program run successfully in the debugger? If not, you can probably step through the code in the debugger to find out what it's complaining about.
|
| Fri Dec 17, 2010 7:17 pm |
|
|
|
zotbotz
Rookie
Joined: Fri Dec 17, 2010 5:11 pm
Posts: 2
|
Re: programming problem, fcs samantha nxt robotc? There isn't any way to Emulate waitForStart() in the debugger, so it wouldn't do anything   . thanks anyway.
|
| Wed Dec 22, 2010 5:16 pm |
|
|
|
MHTS
Guru
Joined: Sun Nov 15, 2009 5:46 am
Posts: 1023
|
Re: programming problem, fcs samantha nxt robotc? There is. If you open the joystick control panel (Game), the radio buttons on "Autonomous Ready", "Autonomous Running", "Teleop ready" and "Teleop Running" are simulating the field control system on various stages of the match. It will send the signal to unblock "waitForStart".
|
| Wed Dec 22, 2010 5:41 pm |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 2 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
