We have a problem with using the three DC Motor controller we have. When we connect two controllers to sensor port S1, everything runs perfectly. However, when we add a third DC Motor controller in the chain of two, RobotC will suddenly crash with nothing but a Windows Exception. After restarting RobotC, compiling any other program will result in the same exception. Re-installing RobotC, the NXT-drivers and downloading the new firmware to the NXT will fix the compiling-issue, but when we try to add the third DC Motor controller, we get the same exception and crash again. We are experiencing this issue on Windows XP and on Windows 7

I'm at the moment not able to post the exception here, because i'm not at school. I'll post it as soon as possible.

Are there any suggestions to fix this issue?


Jaimy

We've experienced this issue too in our testing and it will be fixed with the 2.00.1 release.

Thanks for the report.

This issue has been fixed and will be released with 2.00.1... Thanks for the report!

Thank you very much for fixing this issue. When will version 2.00.1 be released? I can't hardly wait to use the three DC Motor controllers!