|Help with Servo Programming
|Page 1 of 1|
|Author:||Syaro [ Tue Oct 25, 2016 5:48 pm ]|
|Post subject:||Help with Servo Programming|
Hello, I need help with programming a servo using a Vexnet joystick. The servo, we are using is a Futaba S3003. I'll have to program two buttons for a servo, therefore one button would go to a certain degree and then the second button would return the servo back to it's original position. I just need a sample program to go off of, since I cannot find anything on the internet to go off of.
Any advice to how to program it would be helpful too.
|Page 1 of 1||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group