Hi,
I was finishing up my program for my school's robot when a big problem occurred.
Up until now I've used something like...


To control my servos but all the sudden there is a problem.
It says that it can't convert it to a const number and won't compile.
I can use...



and it will compile but the servos won't respond at all.
Could someone please help me?

What is the exact message the compiler gives you?

That's the error message I keep getting.

:Update

Ok I solved my previous problem and now have a new one...
I go to debug and test the program and in the servo debug window it says that the servos are moving but in
reality they aren't. I've even tried setting them to stuff like 50, 100, 255, and 0 and it says that the position is what I told it
to be but on the robot it doesn't even twitch.

I've checked the wiring over and over and it is hooked up correctly the program reads that they are connected but nothing I do effects the servos. Even when the position is changed manually it doesn't register the change. It's like the servos in the program and debugger are in their on little world oblivious to what is really happening.

Please someone tell me what could I be doing wrong if I am doing anything wrong.

Is your servo actually named servo1? Because if it is, try changing it to something else and see if that works.

I've tried renaming them by position and it did pretty much the same thing.
It says their moving in the debug window but in reality they aren't.

You may have a stripped gear inside the servo. Try taking the cover of the servo off and examining the gears to see if all the teeth are intact.

:Update

I found the problem...
It wasn't a programming problem at all it was just
a hardware problem with the servo controller.