|Issues with the Hitechnic Superpro prototype board
|Page 1 of 1|
|Author:||Ninja3047 [ Thu Feb 19, 2015 4:03 pm ]|
|Post subject:||Issues with the Hitechnic Superpro prototype board|
We're having some trouble with our Hitechnic Superpro prototype board, more specifically the read strobe. The read strobe seems to randomly stop working and then start working, but none of the code has changed, so I'm not sure what the problem is. We have confirmed it isn't an issue with the wiring because we used a Logic analyzer to directly read from the pin on the prototype board and received no readings. We also swapped prototype boards to confirm that it wasn't a defect with the board and got the same result. Any help would be appreciated.
FTC Team 4096 (T-[minus]10)
|Author:||FTC4592 [ Thu Mar 12, 2015 5:35 pm ]|
|Post subject:||Re: Issues with the Hitechnic Superpro prototype board|
Posting the code would help with debugging. Also did you use more than one task to access the HiTechnic Super Pro Board by any chance? I ask this because I know that was causing our team trouble when we tried to do analog read in one task and digital read/write in another task. I wrote a fix for the HiTechnic super pro driver but I am still working on making it cleaner before getting it put into the robotc third party driver suite.
|Page 1 of 1||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group