ROBOTC.net forums
http://www.robotc.net/forums/

SuperPro Prototype Board Driver Missing Function
http://www.robotc.net/forums/viewtopic.php?f=41&t=7304
Page 1 of 1

Author:  Ernest3.14 [ Sun Nov 17, 2013 8:02 pm ]
Post subject:  SuperPro Prototype Board Driver Missing Function

I don't know if I'm the only person to notice this, or the only person too stupid to figure it out. :)

In Xander's drivers for RobotC, the one for the SuperPro Prototype Board form HiTechnic has a forward declaration for a function that sets sample rate:
Code:
bool HTSPBsetSamplingTime(tSensors link, byte interval);

However, there is no implementation for this function. Is it actually defined anywhere?

Author:  mightor [ Mon Nov 18, 2013 3:37 am ]
Post subject:  Re: SuperPro Prototype Board Driver Missing Function

If you can't see it anywhere then it most likely has been overlooked. Pop me a mail to remind me :)

= Xander

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/