ROBOTC.net forums
http://www.robotc.net/forums/

IRv2 seeker signal strength?
http://www.robotc.net/forums/viewtopic.php?f=41&t=5194
Page 1 of 1

Author:  FFStudios [ Fri Nov 30, 2012 12:06 pm ]
Post subject:  IRv2 seeker signal strength?

Just read something that says the HiTechnic 1200 IR Seeker also gives a reading from 0 to 255; 0 being no measured signal and 255 being the maximum measured signal. Is it right to think that this means it measures the signal strength of the IR beacon? If so, how do I access these readings? I can only see the direction of the beacon in the debugger from 1-9. Much thanks,

-Zack

Author:  mightor [ Fri Nov 30, 2012 12:16 pm ]
Post subject:  Re: IRv2 seeker signal strength?

Open the samples directory in ROBOTC and navigate to the 3rd party driver suite folder and open the irseeker-v2-test*.c files. They will show you how to use this sensor's more advanced features, using my driver suite.

= Xander

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/