ROBOTC.net forums
http://www.robotc.net/forums/

RobotC NxtCam Help getting started
http://www.robotc.net/forums/viewtopic.php?f=41&t=2750
Page 1 of 1

Author:  ademers [ Tue Nov 16, 2010 3:14 pm ]
Post subject:  RobotC NxtCam Help getting started

I am currently trying work on a program using the NxtCam V2, I am trying to do the motors and sensors setup for the camera but I have no idea what to do
please help!

Author:  mightor [ Tue Nov 16, 2010 3:28 pm ]
Post subject:  Re: RobotC NxtCam Help getting started

Did you look at the video that is on the website? http://rdpartyrobotcdr.sourceforge.net/ ?

When you've executed those steps, you can open your motor and sensors wizard and configure the NXTcam's port as "I2C Custom" or "I2C Custom Fastest", either is fine.

- Xander

Author:  ademers [ Tue Nov 16, 2010 5:24 pm ]
Post subject:  Re: RobotC NxtCam Help getting started

I tried doing that and nothing happened.

Author:  mightor [ Tue Nov 16, 2010 5:47 pm ]
Post subject:  Re: RobotC NxtCam Help getting started

What are you expecting to happen? Be more specific. I can't help you if you are being vague. Describe -exactly- the steps you did. You didn't answer my question about the video; did you watch it?

- Xander

Author:  ademers [ Tue Nov 16, 2010 6:06 pm ]
Post subject:  Re: RobotC NxtCam Help getting started

I went to that website, I downloaded the 3rd Party RobotC Drivers, from that link, I saved the zip file, extracted the files and went to preferences on the RobotC program, clicked on the NXT directories tab, and put that file I just downloaded under the NXT System resource files directory. After this I went to the motors and sensors setup and when I looked to see what types were available under the sensors tab, I looked for the I2C Custom and it was not there

Author:  mightor [ Wed Nov 17, 2010 2:15 am ]
Post subject:  Re: RobotC NxtCam Help getting started

I will ask again... Did you watch the video on the http://rdpartyrobotcdr.sourceforge.net/ website? Specifically from around 1:00 to 1:06

- Xander

Author:  ademers [ Wed Nov 17, 2010 9:10 am ]
Post subject:  Re: RobotC NxtCam Help getting started

I see my mistake, clicked to allow the wrong thing under preferences, thanks for the help!

Author:  mightor [ Wed Nov 17, 2010 9:16 am ]
Post subject:  Re: RobotC NxtCam Help getting started

Ah, the devil is in the details :)

- Xander

Author:  ademers [ Wed Nov 17, 2010 1:53 pm ]
Post subject:  Re: RobotC NxtCam Help getting started

Ok now here is my problem
I am trying to write a program using the camera to identify an object that will be black and one it identifies the object it heads toward it, using the sonar when it is close to the object a claw will close around it, then take it back to an area marked with a different color
I need help with how i should go about doing this because I feel completely lost when it comes to the camera, because other than that I have the program written

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/