ROBOTC.net forums
http://www.robotc.net/forums/

EV3 Arduino Sensor Shield
http://www.robotc.net/forums/viewtopic.php?f=41&t=12434
Page 1 of 1

Author:  Gadgeering [ Sun Nov 08, 2015 3:45 am ]
Post subject:  EV3 Arduino Sensor Shield

I have been working on an EV3 sensor built from a Arduino mini and LSM9DS0 sensor for the last couple of months.



The sensor can feed the EV3 with: Pitch & Roll, Heading, Gyro rate,accelerometer and magnetometer.

Attachment:
File comment: Sensor Block
EV3 Sensor.tiff
EV3 Sensor.tiff [ 136.6 KiB | Viewed 9762 times ]


A special block is imported into the EV3 software and can be used like any other sensor.

Attachment:
File comment: EV3 Arduino Plan
IMG_1720.JPG
IMG_1720.JPG [ 921.16 KiB | Viewed 9762 times ]
Attachment:
File comment: EV3 Arduino Side
IMG_1721.JPG
IMG_1721.JPG [ 887.77 KiB | Viewed 9762 times ]


The Circuit board has been designed to attached to Lego Technic Pegs.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/