ROBOTC.net forums
http://www.robotc.net/forums/

Reloading the Default program onto the Vex Micro Controller
http://www.robotc.net/forums/viewtopic.php?f=21&t=2569
Page 1 of 1

Author:  rmarte [ Mon Sep 06, 2010 10:44 pm ]
Post subject:  Reloading the Default program onto the Vex Micro Controller

I have been practicing writing short program in RobotC with some success. However now I would like to reconfigure the controller (download the default code program) so that it operates as it was sent to me from the factory, with the radio controller.

I have searched your site and other sites for the VEX RobotC default code with no success.

Can you direct me where I can download this code/program (or is this is what is called the "Firmware")

A little guidance would be greatly appreciated.

Thanks in advance

Reg

Author:  jbflot [ Tue Sep 07, 2010 8:42 am ]
Post subject:  Re: Reloading the Default program onto the Vex Micro Controller

The default firmware can be downloaded from here: http://www.vexforum.com/wiki/index.php/ ... _Downloads as "VEX Default Firmware". It is provided by Innovation First.

You can use the firmware downloader in ROBOTC, or the "IFI Loader 4VEX" (also on that page) to download the default firmware.

Author:  rmarte [ Wed Sep 08, 2010 11:15 pm ]
Post subject:  Re: Reloading the Default program onto the Vex Micro Controller

Thank you for this information.

Reg

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/