| View unanswered posts | View active topics |
It is currently Fri Dec 06, 2019 4:51 pm |
|
All times are UTC - 5 hours [ DST ] |
|
Page 1 of 1 |
[ 3 posts ] |
| Print view | Previous topic | Next topic |
Reloading the Default program onto the Vex Micro Controller
| Author | Message |
|---|---|
|
Rookie
Joined: Wed Dec 30, 2009 8:07 pm Posts: 2 
|
 Reloading the Default program onto the Vex Micro ControllerI have been practicing writing short program in RobotC with some success. However now I would like to reconfigure the controller (download the default code program) so that it operates as it was sent to me from the factory, with the radio controller.
I have searched your site and other sites for the VEX RobotC default code with no success. Can you direct me where I can download this code/program (or is this is what is called the "Firmware") A little guidance would be greatly appreciated. Thanks in advance Reg |
| Mon Sep 06, 2010 10:44 pm |
|
|
|
|
Site Admin  Joined: Tue May 15, 2007 9:02 am Posts: 409
|
Re: Reloading the Default program onto the Vex Micro Controller The default firmware can be downloaded from here: http://www.vexforum.com/wiki/index.php/ ... _Downloads as "VEX Default Firmware". It is provided by Innovation First.
You can use the firmware downloader in ROBOTC, or the "IFI Loader 4VEX" (also on that page) to download the default firmware. |
| Tue Sep 07, 2010 8:42 am |
|
|
|
|
Rookie
Joined: Wed Dec 30, 2009 8:07 pm Posts: 2
|
Re: Reloading the Default program onto the Vex Micro Controller Thank you for this information.
Reg |
| Wed Sep 08, 2010 11:15 pm |
|
|
|
Page 1 of 1 |
[ 3 posts ] |
|
All times are UTC - 5 hours [ DST ] |
Who is online |
Users browsing this forum: No registered users and 1 guest |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |
