| View unanswered posts | View active topics |
It is currently Sat Aug 17, 2019 11:12 am |
|
All times are UTC - 5 hours [ DST ] |
|
Page 1 of 1 |
[ 2 posts ] |
| Print view | Previous topic | Next topic |
HELP
| Author | Message |
|---|---|
|
Rookie
Joined: Tue Oct 18, 2011 12:25 am Posts: 1 
|
 HELPI need help with the arm programming. I can't figure it out. Is it motor[rightarmMotor] or motor[armMotor]???
|
| Tue Oct 18, 2011 12:27 am |
|
|
|
|
Site Admin  Joined: Wed Jan 24, 2007 10:44 am Posts: 442 Location: Pittsburgh, PA
|
Re: HELP Which robotics platform are you using? NXT? VEX? The "motor" command sets the value of the power level of a motor with the motor alias being within the square brackets. So if you named your motor "rightarmMotor", then it would be motor[rightarmMotor]. If you named it "armMotor", then it's motor[armMotor]. Check the Robot menu > Motors and Sensors Setup. That should tell you which name to use. If you didn't name any, then there's the place to do it.
_________________ Vu Nguyen Software Training Development Team | Webmaster Need more support? Email ROBOTC Support at support@robotc.net to put in a support ticket Robotc.net| Robomatter Store | Robotics Academy | CS2N |
| Tue Oct 18, 2011 8:28 am |
|
|
|
Page 1 of 1 |
[ 2 posts ] |
|
All times are UTC - 5 hours [ DST ] |
Who is online |
Users browsing this forum: No registered users and 2 guests |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |
