ROBOTC.net forums
http://www.robotc.net/forums/

Can not communicate error
http://www.robotc.net/forums/viewtopic.php?f=11&t=4764
Page 1 of 1

Author:  Bob Borinstein [ Thu Aug 23, 2012 11:10 am ]
Post subject:  Can not communicate error

I have software version 3.08. Where can I find the matching directions for VEX Cortex Configuration over USB? Every time I get to step #6, I get a message stating that the cortex and the computer cannot communicate. I'm using an instruction set that I was told was OK, but I'm not so sure it is up to date-has a 2011 date on it.

Thanks

Author:  JohnWatson [ Thu Aug 23, 2012 3:19 pm ]
Post subject:  Re: Can not communicate error

Hello Bob,

The instructions for installing a Cortex over USB can be found in ROBOTC's built-in Help menu (go to Help->Open Help->Getting Started or press F1 to open the help menu). I also updated your support ticket so check that as well please.

John

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/