I have software version 3.08. Where can I find the matching directions for VEX Cortex Configuration over USB? Every time I get to step #6, I get a message stating that the cortex and the computer cannot communicate. I'm using an instruction set that I was told was OK, but I'm not so sure it is up to date-has a 2011 date on it.
Thu Aug 23, 2012 11:10 am
Joined: Thu May 24, 2012 12:15 pm Posts: 716
Re: Can not communicate error
The instructions for installing a Cortex over USB can be found in ROBOTC's built-in Help menu (go to Help->Open Help->Getting Started or press F1 to open the help menu). I also updated your support ticket so check that as well please.
Users browsing this forum: No registered users and 2 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum