Use of "nMaxRegulatedSpeed12V"
So we're trying to make use of the motor encoder that we've attached to a motor that controls an arm on our robot. We have a 12V Tetrix motor attached to a HiTechnic Motor Controller.
The nMotorEncoder value consistently reads correctly and works in programs. However, we attempted to use the "nMaxRegulatedSpeed12V = x" command that we found here
. This appears to do nothing to the maximum speed of the arm. As I understand it to work, it sets a maximum speed, in encoder counts per second, that the arm will not exceed, where 1440 encoder counts is a single revolution of the motor. However, even absurdly low values (we started at 500, then dropped to 200, then 100, then 50, then 1) for this command have not yielded a noticeable difference in the speed of the arm.
Here's really the only relevant code I have to show: