ROBOTC.net forums
http://www.robotc.net/forums/

Program help - extra DC motors
http://www.robotc.net/forums/viewtopic.php?f=1&t=5528
Page 1 of 1

Author:  lupelletier [ Thu Feb 21, 2013 5:05 pm ]
Post subject:  Program help - extra DC motors

Hello,

We are some what new at this.

We are trying to program a third, forth and fifth DC motors. We are successful using DC motors running on port D and E. We can not figure out how to put three more on. We have the DC motors and DC motor controller

WMA Titans team 5710

Author:  JohnWatson [ Fri Feb 22, 2013 11:34 am ]
Post subject:  Re: Program help - extra DC motors

Before you start using the extra motors, you will need to make sure that they are set up correctly in ROBOTC (we have a ROBOTC wiki guide on setting up HiTechnic Controllers)

Next, you may want to give them aliases to help keep them organized (remembering that 'motorF' is the front-right drive motor is a lot harder than remembering that 'frontRightDrive' is); we also have a ROBOTC wiki guide to help you with this.

Once you have everything set up, you should be able to code the new motors just like you would the other TETRIX DC motors, with the only difference being the names you gave them.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/