| View unanswered posts | View active topics |
It is currently Sat Feb 23, 2019 12:54 pm |
|
All times are UTC - 5 hours [ DST ] |
Program help - extra DC motors
Moderators: mightor, starwarslegokid, miki
|
Page 1 of 1 |
[ 2 posts ] |
| Print view | Previous topic | Next topic |
Program help - extra DC motors
| Author | Message |
|---|---|
|
Rookie
Joined: Thu Feb 21, 2013 4:57 pm Posts: 2 
|
 Program help - extra DC motorsHello,
We are some what new at this. We are trying to program a third, forth and fifth DC motors. We are successful using DC motors running on port D and E. We can not figure out how to put three more on. We have the DC motors and DC motor controller WMA Titans team 5710 |
| Thu Feb 21, 2013 5:05 pm |
|
|
|
|
Site Admin  Joined: Thu May 24, 2012 12:15 pm Posts: 722
|
Re: Program help - extra DC motors Before you start using the extra motors, you will need to make sure that they are set up correctly in ROBOTC (we have a ROBOTC wiki guide on setting up HiTechnic Controllers)
Next, you may want to give them aliases to help keep them organized (remembering that 'motorF' is the front-right drive motor is a lot harder than remembering that 'frontRightDrive' is); we also have a ROBOTC wiki guide to help you with this. Once you have everything set up, you should be able to code the new motors just like you would the other TETRIX DC motors, with the only difference being the names you gave them. _________________ Check out our Blog! And our Facebook page! Need help? Take a look at our updated help documentation and the ROBOTC Forums. |
| Fri Feb 22, 2013 11:34 am |
|
|
|
Page 1 of 1 |
[ 2 posts ] |
|
All times are UTC - 5 hours [ DST ] |
Who is online |
Users browsing this forum: No registered users and 2 guests |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |
