I just upgraded to 3.x and tried to open an old program that uses the Mindsensors Pressure Sensor. Previously I would read the "raw" value and do the calculation to get the correct reading. For some reason, the "raw" value doesn't work when I do the sensor setup, thus the sensor no longer works in my program.

Any ideas?

Well when the switched happened it could lost some of the program. Just check it out again or reply your program onto here and i could try and fix it for you

I got it figured out, thanks. I just removed it from the sensor/motor declarations and manipulated the sensor manually.

Just another case of a RobotC upgrade causing programs to not work anymore and returning error messages.