View unanswered posts | View active topics It is currently Fri Oct 24, 2014 3:15 am






Reply to topic  [ 1 post ] 
"Clicking" Brick and Unpredictable Performance - L 
Author Message
Creator
Creator

Joined: Fri Feb 09, 2007 9:21 am
Posts: 615
Post "Clicking" Brick and Unpredictable Performance - L
At low battery levels the NXT can exhibit unpredictable performance.

This problem exhibits itself when the battery level is high enough to operate the CPUs on the NXT but it is not high enough for the slightly higher voltages required to program flash memory on the NXT CPU. The NXT will behave OK until you perform an operation that tries to write to flash memory. At low voltages, the flash memory operation can result in corrupted memory at unpredictable addresses, not just the address that is trying to be rewritten.

One symptom of this is when the NXT is is firmware reload mode -- i.e. the brick is "clicking" waiting for a reload of firmware -- and the brick refuses to accept the reload and the brick keeps "clicking".

The solution is simple. Replace the batteries!

ROBOTC is "smart" enough to detect this problem. The ROBOTC IDE checks the battery level before trying to download firmware or write a file to the NXT and will abort the operation if the voltage is too low.

However, ROBOTC can't check the voltage if the brick is already in "boot" mode (i.e. it is already clicking) which might occur if you manually put the brick in boot mode via the "secret" button on the bottom of the NXT. Or if boot mode was entered using a different development system.

If your batteries are "weak" then putting a large drain on the batteries -- e.g. operating motors at full power, especially when there's a large load on the motors or even a stall condition -- can pull the battery level below a level for reliable operation of the CPU. This is another case where battery replacement might be the solution to unpredictable performance of your NXT programs.

Note: this problem occurs at voltages that are still high enough that they don't trigger the on-brick "Low Voltage" indication.


Sun Jun 24, 2007 10:30 am
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 1 post ] 

Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software for PTF.