ROBOTC.net forums
http://www.robotc.net/forums/

NXT Ultrasonic Sensor values not correct
http://www.robotc.net/forums/viewtopic.php?f=1&t=19568
Page 1 of 1

Author:  eat-sleep-code [ Thu Aug 10, 2017 5:32 pm ]
Post subject:  NXT Ultrasonic Sensor values not correct

I have an NXT 2.0 system, that I haven't touched in months.

Today, I decided to tinker with it. I downloaded and installed Robot C 4.55. I applied the included firmware to the NXT.

But, the ultrasonic sensors are returning a value of 253 -- no matter how far away a solid object is.

Running "Try Me" shows a value of 253 too.

I tried reverting the firmware back to the stock Lego firmware and running "Try Me" again. With the Lego firmware I get a value of ???????

I tried switching wires, ports, sensors. I keep getting the same behavior.

Any ideas?

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/