NXT motor just stops
Page 1 of 1

Author:  Korndog [ Fri Feb 03, 2017 12:39 pm ]
Post subject:  NXT motor just stops

I have one NXT that when it is programmed, one motor just stops before it should. We are using RobotC and are learning about motor encoders. The students are allowing plenty of time to complete the task but one motor will stop before the target distance is reached, while the other keeps on running. I have checked to make sure the cables are fully connected. The only other thinkg I can think to try is to switch the motor cables. Other than this, does anyone have any ideas?

Thank you.

Author:  CARBOT [ Wed Feb 15, 2017 1:03 pm ]
Post subject:  Re: NXT motor just stops

Please post your code to people to help you better.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group