View unanswered posts | View active topics It is currently Sun Feb 25, 2018 9:39 pm






Reply to topic  [ 1 post ] 
cannot get gyro to reset 
Author Message
Rookie

Joined: Tue Aug 14, 2007 1:38 pm
Posts: 18
Post cannot get gyro to reset
I have used the mindstorms for many years with RobotC 3.x but am now replacing class set with EV3's. I was trying out the gyro with sensorType[S2 ] = sensorEV3_Gyro. It sets up fine on the debug window and I can step thrugh the sensorType and watch the degrees changing. When I try to reset it with resetGyro(S2)and I step through, the mode is "angle" when it sets the type. i can turn the gyro and see the angle changing on the debug window. When i step through resetGyro(S2) Mode changes to "rate and angle" and the value goes from ex. 20 to -20 not 0. I also tried sensorReset(S2) same result. BUT if I put both resetGyro(S2) AND sensorReset(S2) the value resets to 0 after whichever is second.

Where am I going wrong? I went to the help, but only online help works. Help does not work from within RobotC. Found no ideas with online help .

Thanks for any help,
Been using RobotC since the early days. LOVE it.


Thu Jan 26, 2017 1:29 pm
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 1 post ] 

Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software for PTF.