Archive for the ‘Angle’ tag
Programming your robot to make precise turns can be a source of frustration for some students as they begin to learn ROBOTC. Oftentimes, when students are just learning programming, all of the movements of their robots are based on timing. When programming a robot to move forward or backwards, a small error or a small amount of inconsistency can usually be overcome. With turning, however, inconsistencies and small errors can lead to larger errors and the frustration I mentioned earlier.
At this point, students learn that sensors can be used to improve the movement of their robots. With the VEX IQ, a Gyro Sensor is provided that eliminates any guesswork when it comes to programming your robot to turn.
The Gyro Sensor measures the rotational angle of the robot. If you look at the Gyro Sensor, you will see an arrow that points in a counter-clockwise direction. That is the default positive direction. Therefore, as long as the sensor is mounted flat on the robot it picks up the parallel angle to the ground. The sensor then registers the current position as a zero point. If the robot turns counter-clockwise, it registers as a positive value. If it turns clockwise, the sensor registers a negative value. We can see this applied with the following illustration:
We can program the Gyro Sensor using Natural Language or full ROBOTC. To use Natural Language, you just need to make sure that the Gyro Sensor is plugged into port 4. Let’s take a look at some ways to program the Gyro Sensor with Natural Language.
With this program, getGyroDegrees returns the current rotational value of the sensor in units of degrees. When making gyro-based turns, it is best to reset the gyro sensor before each turn, so the resetGyro command is utilized. With the example, we want the robot to turn until the getGyroDegrees command returns a value (from the Gyro Sensor) of 90 degrees. Therefore, we use the repeatUntil command. When we run this program, our robot should make a 90 degree left turn. Note that the robot may turn more than 90 degrees due to drift, which is caused by momentum. If this occurs, just slow down the speed of the motors. That should eliminate the drift.
We can apply the same commands to program our robot to make a right turn.
What I did when first showing the students the Gyro Sensor was to have them see the sensor work with the debugger screen. I used a sample program utilizing full ROBOTC with this activity. The sample program we used was in the Gyro Sensor Folder, and it is called Gyro Display Values. The students compiled and downloaded the program. They kept the USB cables plugged into their robots so they could see the values of the Gyro Sensor on the debugger screen. To access the debugger windows, go to the Robot menu, click on Debugger Windows, and then select Sensors.
The students can now run their program, physically move their robot, and see how the values of the Gyro Sensor change via the debugger screen.
The VEX IQ Gyro Sensor is extremely useful and easy to program, and the students have a lot of fun using this sensor.
– Jason McKenna